Four quartz samples of equal size and shape were placed in a stream. Which of the four quartz samples below has most likely been transported farthest in the stream?

Answer:

The time taken to reach the maximum height is 3.20 seconds

Explanation:

The given parameters are;

The initial height from which the volcano erupts the lava bomb = 64.4 m

The initial upward velocity of the lava bomb = 31.4 m/s

The acceleration due to gravity, g = 9.8 m/s²

The time it takes the lava bomb to reach its maximum height, t, is given by the following kinematic equation as follows;

v = u - g·t

Where;

v = The final velocity  = 0 m/s at maximum height

u = The initial velocity = 31.4 m/s

g = The acceleration due to gravity = 9.8 m/s²

t = The time taken to reach the maximum height

Substituting the values gives;

0 = 31.4 - 9.8 × t

∴ 31.4 = 9.8 × t

t = 31.4/9.8  ≈ 3.204

The time taken to reach the maximum height rounded to three significant figures = t ≈ 3.20 seconds

Answer:

its B

Explanation:

the movement of charged particles in a conductor

Charged particles move through a conductor best describes an Electric current.

A stream of charged particles, such as electrons or ions, traveling through an electrical conductor or a vacuum is known as an electric current.

Charge carriers, which can be any of a number of particle kinds depending on the conductor, are the moving particles. Electrons flowing over a wire are frequently used as charge carriers in electric circuits.

They can be electrons or holes in semiconductors. Ions are the charge carriers in an electrolyte, whereas ions and electrons are the charge carriers in plasma, an ionized gas.

Therefore, Charged particles move through a conductor best describes an Electric current.

To learn more about electric current, refer to the link:

https://brainly.com/question/2264542

#SPJ2

Explanation:

We know that kWh is a commercial unit of energy.

Also, 1 Joule = 1 watt × 1 seconds

[tex]1\ kWh=1kW \times 1\ h[/tex]

Since ,1 h = 3600 s and 1kW = 1000 W

[tex]1\ kWh=1000\ W \times 3600\ s\\\\1\ kWh = 36\times 10^5\ W-s\\\\1\ kWh=36\times 10^5\ J[/tex]

So, the relation is : [tex]1\ kWh=36\times 10^5\ J[/tex]

1 watt is defined as the power of an appliance when the energy is transferred at a rate of 1 Joule per second.

Answer:

Explanation:

The potential energy of a body can be found by using the formula

PE = mgh

where

m is the mass

h is the height

g is the acceleration due to gravity which is 10 m/s²

From the question we have

PE = 1.5 × 10 × 0.22

We have the final answer as

Hope this helps you

Answer:

it makes us less stressful and more calm so we can do things easier

Explanation:

Answer:

a. The rock takes 2.02 seconds to hit the ground

b. The rock lands at 20,2 m from the base of the cliff

Explanation:

Horizontal motion occurs when an object is thrown horizontally with an initial speed v from a height h above the ground. When it happens, the object moves through a curved path determined by gravity until it hits the ground.

The time taken by the object to hit the ground is calculated by:

[tex]\displaystyle t=\sqrt{\frac{2h}{g}}[/tex]

The range is defined as the maximum horizontal distance traveled by the object and it can be calculated as follows:

[tex]\displaystyle d=v.t[/tex]

The man is standing on the edge of the h=20 m cliff and throws a rock with a horizontal speed of v=10 m/s.

a,

The time taken by the rock to reach the ground is:

[tex]\displaystyle t=\sqrt{\frac{2*20}{9.8}}[/tex]

[tex]\displaystyle t=\sqrt{4.0816}[/tex]

t = 2.02 s

The rock takes 2.02 seconds to hit the ground

b.

The range is calculated now:

[tex]\displaystyle d=10\cdot 2.02[/tex]

d = 20.2 m

The rock lands at 20,2 m from the base of the cliff

Answer:

-1/6 im sure to this answer

Explanation:

mark brainliest

Answer:

-1/6

Explanation:

pick her as the brainliest

Answer:

6.67x10^-11 N-m^2/kg^2

Explanation:

Answer:

The amount of power will be increased.

Explanation:

If the work remains constant but the time is reduced the power increases. Since power is defined as the relationship between work overtime. By means of the following equation, we can see this relationship.

[tex]P=W/t[/tex]

where:

P = power [Watts]

W = work [J] (units of joules)

t = time [s]

Let's assume with an example the above written.

If we have an electric motor that exerts a work of 950 [J], and the time used is 5 [s], the power is:

[tex]P = 950/5\\P = 190 [W][/tex]

Now if we want to accelerate the work done and use 2 seconds for the time, we will have:

[tex]P=950/2\\P=475 [W][/tex]

We want to see how maintaining the work constant but reducing the time in which it occurs affects the power. We will see that the power increases.

We define power as the amount of work done per unit of time.

So we can compute power as the quotient between the work done and the time in which it is done.

So, if we reduce the time in which the work is done, then the denominator is smaller, thus, the power will be larger.

This means that maintaining the work constant, and reducing the time in which it is done, increases the amount of power exerted.

If you want to learn more, you can read:

https://brainly.com/question/3854047

Answer:

No

Explanation:

No, Marc did not make it on time for dinner.

The time duration between 12:00 and 18:00 is 6 hours.

Total distance that needs to be covered from his house to his mum's house and back = 300 miles x 2 = 600 miles

Time that would be needed to cover 600 miles to his mum's house at an average speed of 45 mph = distance/speed

    = 600/45

            = 13.33 hours

The required time to cover the distance by Marc is approximately 13.33 hours. If he leaves the house by 12:00, he will definitely not get back 6 hours after. Hence, he could not have made it for dinner.

Answer:

When a motorcycle takes a turn, centrifugal force—in this case, friction between the tires and the road—pushes it towards the center. This basic physics explains why riders can lean into turns without falling. However, when an outside force disrupts or unbalances these forces, the vehicle crashes. that is the only one that I can answer for you. :)

Answer:

Explanation:

This question needs more information (Sedan)

Answer:d

Explanation:

Answer:

Jupiter

Explanation:

Since the mass of Jupiter is the greatest from the given choices, it will exert the most force on any object orbiting 100km above its surface.

This is compliance with the Newton's law of universal gravitation which states that "the force of attraction between two bodies is directly proportional to the magnitude of their masses and inversely proportional to the distances between them".

Answer:

Sample Response: Jupiter would have the strongest gravitational pull on a satellite orbiting above its surface because gravity is directly proportional to mass and Jupiter is the most massive planet.

Explanation:

edge 2021

Answer:

Because it is always the substance’s density divided by the density of water which is 1 g/cm 3

Explanation:

The density of water is 1g/cm³;

  Specific gravity = [tex]\frac{density of substance}{density of water}[/tex]

Since specific gravity is a relative comparison of a substance density with that of water, the values always the same.

Density of water is 1 and it will have no effect on the density of the substance.

The only difference is in the units. The density of a substance will have a unit but that of the specific gravity will have no unit.

Numerically, dividing by 1 has no implication.

Answer:  the answer is C

Explanation:Specific gravity is the density of a substance divided by the density of water. Since (at standard temperature and pressure) water has a density of 1 gram/cm3, and since all of the units cancel, specific gravity is usually very close to the same value as density

Answer:

10 Kg

Explanation:

Force is equal to mass times acceleration

therefore mass is equal to force divided by acceleration

please mark me brainliest

Answer:

first lets do the anti parralel part of forces

we get 18. 25-15 =3.25 to north

then ww use phytagores theorem

3.25^2+4.75^2=c(resultant )

10.56+22.56=33.12

square root of 33.12 is 5.75

Answer:

Yes, cause when listener is far away from music source... the listener feels it's pleasant.... but when observer approaches near loudspeaker... sound become unpleasant..........sound becomes noise when frequency crosses 85 Decibels.....so you can say that the voice from loudspeaker also get shrill when the listener reaches the surrounding source......

Answer:

22236 mi

Explanation:

Answer: wavelength is the length of the wave, example the length of a sound wave.

Velocity is also known as speed.

Explanation:

Answer:

Dr Hutson is the author of several books among them: John Adams and the Diplomacy of the American Revolution (1980); winner of the Gilbert Chinard Prize, 1981; To Make All Laws: The Congress of the United States, 1789-1989 (Washington and Boston, 1989-90; 4th edition, Washington, 1990); The Sister Republics

Answer:

Dr Hutson is the author of several books among them: John Adams and the Diplomacy of the American Revolution (1980); winner of the Gilbert Chinard Prize, 1981; To Make All Laws: The Congress of the United States, 1789-1989 (Washington and Boston, 1989-90; 4th edition, Washington, 1990); The Sister Republics: ... Explanation: HOPE I HELPED!!!!!

Answer:

.

Explanation:

.

Newton 2ns law state that external forces that exert on an object is proportional to the mass and the acceleration of an object

Formula : ΣF = ma

ask me if you're confused with my answer

Answer:

1.92 J

Explanation:

From the question given above, the following data were obtained:

Mass (m) = 200 Kg

Spring constant (K) = 10⁶ N/m

Workdone =?

Next, we shall determine the force exerted on the spring. This can be obtained as follow:

Mass (m) = 200 Kg

Acceleration due to gravity (g) = 9.8 m/s²

Force (F) =?

F = m × g

F = 200 × 9.8

F = 1960 N

Next we shall determine the extent to which the spring stretches. This can be obtained as follow:

Spring constant (K) = 10⁶ N/m

Force (F) = 1960 N

Extention (e) =?

F = Ke

1960 = 10⁶ × e

Divide both side by 10⁶

e = 1960 / 10⁶

e = 0.00196 m

Finally, we shall determine energy (Workdone) on the spring as follow:

Spring constant (K) = 10⁶ N/m

Extention (e) = 0.00196 m

Energy (E) =?

E = ½Ke²

E = ½ × 10⁶ × (0.00196)²

E = 1.92 J

Therefore, the Workdone on the spring is 1.92 J